Valmet works close to our customers through 100 service centers. Our experts are also available remotely with the help of industrial internet technologies.

We deliver services to optimize the performance of your production process - to get the most out of the least. We offer a full range of production consumables to maximize production, minimize lifecycle costs and keep your production performance reliable. Consumable agreements are always tailored specifically for each production line.

Valmet’s process support and optimization services help maximize your process performance by utilizing our technology and automation expertise. You can achieve reduced energy and raw material costs, reduced process variability, optimized quality and production, and enhanced environmental performance.


10 of 149 documents
  • Feb 18, 2020

    Field Report - Slitter blade and band sharpening

    Slitters must be sharp and properly sharpened. The best way to maintain a continual supply of sharp slitter blades is to use the Valmet BladePool service. If, however, you choose to do your own sharpening, here are some general instructions for sharpening at the mill.

  • Feb 11, 2020

    Field Report - Spreader roll problems, solutions and services

    Spreaders deal with web instability, using the principles of tension and traction to overcome dishing and interweaving. Valmet spreader roll services ensure spreading efficiency with all-round cost control.

  • Feb 4, 2020

    Field Report - Felt roll safety

    When lifting, operating and servicing the rolls, obey the OEM and mill safety instructions regarding lifting points, nips, lifting instruments and guards in order to maximize occupational safety.

  • Jan 28, 2020

    Field Report - Blade-type doctors, design and operation

    Doctors are used to scrape foreign material off rolls or to redirect the web to prevent wrapping around rolls. Doctor components vary, but all blade type doctors will have blade(s), blade holder(s) and beam. Heaters, oscillators, air blows and catch pans are common additional options.

  • Jan 21, 2020

    Field Report - General reel service and adjustments

    Many reel service actions and adjustments are common to all paper machine reels. This article reviews on-the-run (OTR) monitoring of the reel, as well as long-term (20 year) checks such as screw torques and critical seam weldments. Consumables must be inspected and replaced as needed, especially actuators and cylinder seals.

  • Jan 14, 2020

    Field Report - Understanding coater blade angle vs. loading tube pressure

    For a given blade tip bevel, when load tube pressure is increased, the blade angle will decrease, resulting in the blade running on its heel for a while. This, along with the additional bending pressure at the blade tip, will reduce coat weight. It is important to understand the interaction between blade angle, blade tip angle and loading tube pressure.

  • Jan 7, 2020

    Field Report - Coater blade angle measurement and interpretation

    Measuring and interpreting coater blade wear angle can avoid problems such as scratching, poor coat weight appearance, wet bleeding and weeping at the blade tip. Correct positioning of the blade on its bevel will optimize sheet smoothness.

  • Dec 17, 2019

    Field Report - Size press roll wear, a case study

    A P&W paper machine suffered from excess wear on the back edge of the bottom size press roll. The problem was traced to the size press synchronization shaft. When the shaft was replaced, the roll wear problem went away.

  • Dec 10, 2019

    Field Report - Reel process audits

    Reel equipment can take a beating during normal operation. Periodic inspections of the reel equipment are recommended to develop a baseline with regard to its process variables and mechanical condition.

  • Nov 26, 2019

    Field Report - Size press edge wipe setup

    Improper setup of a size press edge wipe when running starch results in poor doctoring results outside the sheet path. The extension of the wipe past the holder is a critical part of the edge wipe setup.


10 of 149 documents